Abatement Technologies Air Duct Cleaning Nationwide

Abatement Technologies Air Duct Cleaning in New Braunfels: What to Know First

We provide independent Abatement Technologies air duct cleaning in New Braunfels, typically completed in one scheduled visit with a written price delivered before any panel comes off. Most residential Abatement Technologies systems we service run between $380 and $620 for a full cleaning, depending on duct run count and what the inspection camera actually shows. We’re not affiliated with Abatement Technologies - we’re an independent service provider - and we back every job with our 365-Day Done Right Promise in writing.

Call (830) 549-6847

This page is for Abatement Technologies owners in New Braunfels who want to know what a real cleaning involves, what it costs, and how to avoid the $79 coupon that turns into a $900 upsell. Call (830) 549-6847 for a free estimate with a written price.

How Abatement Technologies Products Fail - and How We Fix Them

• PREDATOR 750 Series - plenum seal degradation. The PREDATOR 750’s plenum gaskets harden faster than spec in New Braunfels heat, especially in attics that hit 140°F in July. We see supply leaks that pull attic dust straight into living spaces. Our fix: replace the gasket with a high-temp silicone seal rated for Texas attic conditions, then pressure-test the plenum before we close it.
• BD2K Series - blower wheel imbalance from debris loading. The BD2K’s forward-curved blower wheel loads unevenly when return ducts pull heavy pollen and limestone dust common in Comal County. That imbalance transfers to the motor bearings. We pull the wheel, clean it on a balancing stand, and check runout to 0.002″ before reassembly.
• ABATEMENT HEPA-AIRE - filter bypass from frame warp. The HEPA-AIRE’s aluminum filter frames can bow after repeated humidity cycles in New Braunfels, creating a gap where dirty air bypasses the HEPA. We measure frame flatness with a straightedge and shim or replace the frame so the seal is continuous.
• PORTACOUNT Pro - sampling tube contamination giving false negatives. The PORTACOUNT’s sampling tubes cake with fine Texas Hill Country caliche dust, which throws off post-cleaning verification readings. We purge and calibrate the tube before and after every job, and we document the baseline and final readings in your job record.
• Older ABATEMENT 600-series - flex duct collapse at the trunk connection. The 600-series units we find in New Braunfels homes built 2015-2019 often have flex duct that was pulled too tight at the trunk tap. The spiral wire fatigues and the duct pinches. We cut back to sound wire, install a proper metal sleeve, and support the span so it doesn’t repeat.

Our Abatement Technologies Air Duct Cleaning Process

1. 1
   Inspection with photo documentation. We feed a camera through every duct run and show you the findings before quoting. Haven Standard Clause 1: written price before work starts, no exceptions.
2. 2
   System isolation and negative-pressure setup. We seal registers and connect our Nikro or Abatement Technologies HEPA-AIRE portable collector to create controlled suction - not a shop vac blowing dust through your house.
3. 3
   Agitation and extraction per duct material. Rotobrush for metal duct, softer poly brushes for flex, with vacuum draw matched to the duct diameter so we don’t collapse lightweight runs.
4. 4
   Component-level cleaning. Blower wheel, evaporator coil (if accessible), and plenum get hand-cleaned; we don’t pretend the ductwork is clean while the air handler is still dirty.
5. 5
   Post-cleaning verification and photo record. Camera goes back in. You get before-and-after photos of every run, plus the written scope and your 365-Day Done Right Promise.

Before

After

What Abatement Technologies Air Duct Cleaning Costs in New Braunfels

What moves the price: duct run count, accessibility (crawl space vs. attic), whether we find collapsed flex or disconnected boots that need repair, and if the blower chamber requires removal for proper cleaning. We don’t do per-vent pricing - one flat price per system, agreed in writing before we start. Call (830) 549-6847 for your exact number; estimates are free.

Why New Braunfels Homeowners Call CleanRun Air Duct Cleaning New Braunfels for Abatement Technologies Work

We’ve cleaned Abatement Technologies systems in New Braunfels since 2013 - over 52,000 homes, every one with a written price first and a photo record at the end. Our technicians are background-checked, uniformed, and identified by name before arrival under Haven Standard Clause 3: Verified Crews. Tomas Reyes, our owner, learned to read ductwork at BOCES Westchester and still trains every technician personally on Abatement Technologies-specific configurations.

We also service Lennox, Trane, and Carrier systems, which matters when your home has mixed-brand HVAC or when you’re comparing whether to repair an older Abatement Technologies unit or replace with something else. The 365-Day Done Right Promise means if the work isn’t right, we make it right - backed in writing, not subject to manager approval. And if you have a competitor’s written estimate, we provide a free second opinion with our number next to it.

FAQs