Abatement Technologies Air Quality & Sanitizing Nationwide

Abatement Technologies Air Quality & Sanitizing in New Braunfels: What to Know First

We provide independent Abatement Technologies air quality and sanitizing services in New Braunfels, with most jobs scheduled within a week and completed in a single visit. Every job starts with a written price before any work begins - no per-vent bait-and-switch, no coupon theatrics. Typical whole-system sanitizing and air quality treatment for Abatement Technologies-equipped homes in New Braunfels runs $340-$680 depending on system size and what the camera shows inside the ductwork.

Call (830) 549-6847

This page is for homeowners who already own Abatement Technologies air filtration, UV, or sanitizing equipment and need service that protects their investment without voiding warranties or cutting corners on parts. If you’re seeing musty odors, elevated allergen symptoms, or your Abatement Technologies UV-C lamp has gone dark, we can show you exactly what’s happening inside the system before you commit to anything. Call (830) 549-6847 for a free estimate.

How Abatement Technologies Products Fail - and How We Fix Them

• PREDATOR 360-CD UV-C units with dimmed or flickering lamps. The 360-CD series uses high-output UV-C lamps rated for 9,000 hours, but in New Braunfels they often degrade faster due to voltage fluctuation during summer peak demand and the mineral content in local well water that affects cooling coils upstream. We measure actual UV output with a radiometer, not just visual inspection, and install OEM-spec replacement lamps or document why the ballast itself has failed.
• HEPA-AIRE portable air scrubbers with clogged final filters and reduced CFM. The HEPA-AIRE PAS series pulls 500-1,200 CFM depending on model, but when the final HEPA loads up with Hill Country pollen and construction dust from New Braunfels’ rapid development, the motor works harder and airflow drops before the filter change light triggers. We test actual CFM at the outlet with a calibrated anemometer, replace the full filter stack (pre-filter, carbon, HEPA), and log the before-and-after numbers.
• ABATEMENT CAPTURE portable containment units with compromised negative pressure. The CAPTURE series relies on sealed gaskets and proper manifold alignment; we’ve found units in New Braunfels homes where the gasket has hardened from attic heat cycling (150+ summer days above 95°F) and the unit is pulling unfiltered return air around the seal. We replace with OEM gasket kits and verify negative pressure with a magnehelic gauge.
• BD2X bipolar ionization generators with inactive ion emitters. The BD2X series uses brush-style emitters that foul with cooking oils and pet dander; in homes near the Comal or Guadalupe rivers, we’ve also seen corrosion from higher ambient humidity. We clean emitters with manufacturer-specified solvents only - never abrasive pads that alter the emitter geometry - and test ion output before closing the panel.
• Abatement Technologies inline HEPA housings with bypass leakage at the door seal. The HEPA housings installed in New Braunfels new construction (2015-2022 builds especially) sometimes arrive with door latches that loosen after thermal cycling. We torque to spec, replace the silicone door gasket if it’s taken a set, and run a smoke pencil test to confirm zero bypass - because a HEPA with 5% bypass is just an expensive noise maker.

Our Abatement Technologies Air Quality & Sanitizing Process

1. 1
   System identification and written scope. We document the exact Abatement Technologies model, serial, and install date, then photograph the current state of filters, lamps, and coil surfaces. The written scope and price are delivered before any panel comes off - Haven Standard Clause 1.
2. 2
   Diagnostics with measured data. UV output in microwatts per square centimeter, airflow in CFM, pressure differential across HEPA banks, ion density where applicable. We don’t guess; we meter.
3. 3
   Parts decision: OEM or verified equivalent. For Abatement Technologies UV lamps and HEPA filters, we stock OEM where it protects warranty coverage. For gaskets and hardware, we use quality aftermarket that meets the original spec and costs less - and we tell you which is which before ordering.
4. 4
   Service execution with photo documentation. Every duct run, every filter bank, every coil face is photographed before and after. The photo record is part of your job file, not an upsell.
5. 5
   Post-service verification. We re-meter the same points from step two and show you the numbers. If the UV lamp reads 55 µW/cm² after replacement and it was 8 before, you see the difference in data, not just our word.
6. 6
   Written guarantee and record delivery. The 365-Day Done Right Promise is printed on your invoice, along with the photo record link and the meter readings. Haven Standard Clause 5: Documented Accountability.

Before

After

What Abatement Technologies Air Quality & Sanitizing Costs in New Braunfels

These are whole-system prices, not per-vent teases that triple once the truck arrives. The written price you receive before work starts is the price on the invoice after. If you’ve received another estimate, bring it - Haven Standard Clause 6 is our Free Second Opinion, no cost to compare.

Call (830) 549-6847 for a free estimate. We’ll show you what the camera sees, name the price in writing, and let you decide without pressure.

Why New Braunfels Homeowners Call CleanRun Air Duct Cleaning New Braunfels for Abatement Technologies Work

We’ve worked on Abatement Technologies equipment in New Braunfels since 2013, from the compact HEPA-AIRE units in condos near the downtown riverwalk to full PREDATOR UV systems in homes along the Interstate 35 corridor. Tomas Reyes, our owner, learned to read ductwork at BOCES Westchester and has spent well over a decade crawling attics here - including older homes near the Gruene Historic District where flex duct from the late eighties creates problems no brand-name equipment can solve alone.

Our technicians are background-checked, uniformed, and identified by name before arrival - Haven Standard Clause 3: Verified Crews. We also service Lennox, Trane, and Carrier systems, which matters when your Abatement Technologies air scrubber is integrated with a mixed-manufacturer HVAC setup and the problem turns out to be upstream in the coil, not the filtration unit itself.

Every job ends with a Documented Photo Record and the 365-Day Done Right Promise in writing. Not because we expect callbacks, but because we document everything - including our own accountability.

FAQs